R6 Siege ZoomTool v1.1 (AGOC For Any Operator)

[shahin2321]

it zooms the upper left of the screen

it doesn't work good for me . its zoomed into the left side of my screen not in the center !

ok , im gonna take a look at this , see if i can make it work for every res

[Seri0n]

Doesnt zoom into the centre for me (only shows the left metal side bar thing of the scope).




HAAAAAAAAAAAAALP MEEEEEEEEEEEEEEEEEEE


btw i use 1920x1080

[skyx54]

work's bad in 1280x1024 but good work

[shahin2321]

work's bad in 1280x1024 but good work

Doesnt zoom into the centre for me (only shows the left metal side bar thing of the scope).




HAAAAAAAAAAAAALP MEEEEEEEEEEEEEEEEEEE


btw i use 1920x1080

its currently working on 1920x1080 monitor resolution only
but im looking forward to make it work for other resolutions , be patience

[Seri0n]

its currently working on 1920x1080 monitor resolution only
but im looking forward to make it work for other resolutions , be patience

Okay <3 btw im using 1920x1080 res monitor yet its not working. Probably a problem on my side then

[Ali Akbar]

Okay <3 btw im using 1920x1080 res monitor yet its not working. Probably a problem on my side then

Me too im one 1920 and has the same problem

[For3v3rkill]

Doesnt zoom into the centre for me (only shows the left metal side bar thing of the scope).




HAAAAAAAAAAAAALP MEEEEEEEEEEEEEEEEEEE


btw i use 1920x1080

same. I try to use ALL the another resolution, doenst work

[iamthebestnoob]

https: //i.imgur .com/fQ4CZuU.png?1
https: //i.imgur .com/Ddawj7k.png?1

Where I look vs where it magnifies
My resolution is 1920 x 1080

Any chance of making it so you can change where the zoom focuses ?

[styletuning]

* Enable/Disable------ this dont work for me.. i need disable zoom for run...

[Kicke02]

it doesn't work good for me . its zoomed into the left side of my screen not in the center !

That's most likely because of your monitor like dakhia said.

[SonicMastr]

That's most likely because of your monitor like dakhia said.

No it's not. The same thing happens at 1080p. It's the program

[silverar1]

it works confirmed 1920x1080 72Hz

[brunovleao]

It does not work for me, when I pull the gun's aim, blinks and disappears from my screen.

[dwiofnow]

is it still working and detected?

- - - Updated - - -

*is it still working and undetected?

[PauloPaulo123]

You can change the focus of the zoom when you open up the source in Visual Studio and then go to the Magnifier.cs file. Search for height and width - default was something around -200 - and adjust it for your monitor.
The coordinates of the bottom left corner of your screen are 0 0.

(I managed it without any knowledge of programming languages. wont be that difficult)