Trouble finding water offset(or catch address) for Nippy's fishing bot v1.5.0

[Flippityflop]

Not sure what I'm doing wrong but every time I put offsets from my catch scan into the waterOffset it doesn't work. It either pulls in too early or it never pulls in at all.

My base address: 0x00EDFA14
My stateWaterOffset: 0x68 + 0xf4 + 0xd4 + 0x84 + 0x68 + 0x8 + 0x6d4

1) I scan for 1 when the bait starts bobbing up and down, and I scan for 0 when I'm not fishing
2) I do this until I get down to between 10 and 5 results, then I take the address at the very top
3) Next, I pointer scan the taken address
4) To create my pointer file I use this setting: Max different offsets per node = 7, Nr of threads scanning = 3, Max level = 7
This gives the same number of offsets as in my stateWaterOffset.
5) I close trove, reopen it and then add it again into cheat engine
6) I repeat steps 1-3
6) I re-scan my pointer file using the new address to get the offsets
7) I find the same base address I use for waterStateOffset (0x00EDFA14) in the scan, then I enter the offsets next to it into my stateWaterSet

Any help would be great.

[Kurama<3]

Not sure what I'm doing wrong but every time I put an offset into the waterOffset it doesn't work.

Elaborate that sentence please.

[Flippityflop]

After doing everything I listed above I get a whole lot of base address, each having 7 offsets (offset 0 to offset 6). I pick the one which has the same base address as the one I use for the waterStateOffset. I enter the offsets next to that base address into the waterOffset in the .ini file (e.g. WaterOffset=0x8+0xb4+0x28+0x22c). The problem is that none of offsets I enter seem to work as they either pull in too early or they never pull in at all.
Strange thing is when I used someone else's waterOffset it worked flawlessly with my chosen base address.

[Morty2001]

if you get the offset, please send me <3

[Flippityflop]

Nvm I found what I did wrong. I was scanning the wrong address when searching for the waterOffset. Its works perfectly now.

[ELDEVILDESOL]

Can you help me pls? xd
I find my Pointer and WaterState offset, and put in on Nippy's, then I start the bot and it says Water Liquid detected. All good
But when I close Trove and open the bot again, it doesn't detect the Liquid.
What can I do?, Why not detecting anymore? :C
Need to do all the process again everytime I open a Trove client? Because I want to start the bot with multiple accounts at the same time
Sorry for bad english

[Tisako]

But when I close Trove and open the bot again, it doesn't detect the Liquid.

You found the wrong pointers ..

[ELDEVILDESOL]

I find same pointers every scan, I don't know what I'm doing bad. hmmm