Warrock closes after injection. Injector is not detected.

[jacky5354]

After I inject the .dll file, the injector says "successfully injected", but when warrock loads up after the hackshield, it goes to a black screen and closes. Any solutions?

[AeroMan]

Try use another injector or another bit type injector

[IHelper]

open warrock
press ok
press ok again
open the injector
also download gamebooster

[markopark4]

or just open injector and then warrock it WORK

[warrockhacking111]

or you could have massive lagg so warrock just gets closed down

[Adrian96]

I had this same exact problem. Im guessing your on Vista too. PM Me and ill send you something that makes the hack work but you should download CCleaner and net framework 4.0 For Vista. Dont forget to PM Me. ;P

[jacky5354]

I have CCleaner, and I dont have lagg. I've did everything, it just suddenly happened.

[ghostracerx]

I had to change speed of my injector after this latest update xD. Try a diff injector*cough* warlordv.2 and as I think someone already stated, run as admin.

[jacky5354]

The injector is not a problem, I think it is just the warrock data not allowing me to inject hacks.

[ghostracerx]

If your on vista7 you need to run injector as admin^^ Also there was just a huge update and hacks had to be restructured. So none of the old hacks were working prior to 22nd i believe.

[Lukas59]

try an other one.

[jacky5354]

No, i have updated hacks, This problem occured before november/ october halloween patch.