Stavane Macro V1.0

[Riddick]

Its great with some weapons. How many ms for M4a1 Freedom? and SA58 Para i was on 21 Ms but its low and 45 slower -.-

For M4 MKIII/Groza I use 11, and Fal Cannon/PARA I use 21.

[savage10]

its detected already.. =(( qq

[Riddick]

This is not detected as it self hex edits on close. You need this here look: https://www.mpgh.net/forum/289-allian...ml#post7985690

[savage10]

oh..ok sir i will try that...thank you sir riddick

---------- Post added at 11:13 AM ---------- Previous post was at 11:08 AM ----------

This is not detected as it self hex edits on close. You need this here look: https://www.mpgh.net/forum/289-allian...ml#post7985690

Sir its still detected for me..i follow the instruction but still detected.... do i need to hex edit 1st????

[Riddick]

oh..ok sir i will try that...thank you sir riddick

---------- Post added at 11:13 AM ---------- Previous post was at 11:08 AM ----------



Sir its still detected for me..i follow the instruction but still detected.... do i need to hex edit 1st????

It's self hex edits on close so it should not be that. Have you tried it as few times and re-started you PC?

I'll have to test it later, but can't right now as my design software gets detected by xigncode and I need to clean and reboot.

[savage10]

i think sir its detected already..coz a while ago it work for me... but i try to reconnect today i saw the xigncode logo below.. it dl something... i think its detected now.

[kevix4]

This is not detected as it self hex edits on close. You need this here look: https://www.mpgh.net/forum/289-allian...ml#post7985690

ive tried all u said . But keep reduce hack and close after with the xigncode error message . Ive tried all solution given , but still not work and that for all macro like Macro pro and eXmacro . it's scared..

[Riddick]

Detected. Closed]