==KAMI BLURB== Manual kami is a lot more effective if you know how to use it correctly. If you don't this is probably still more decent than no kami at all. The x number tells you how far you're horizontally away from the monster, so if you're mele you would make it like 25, and if you were ranged you would make it like 200
The y number is how far you're away from monster vertically; I think a negative y value means above.
It will have like 5-8 second moments where it wastes time and mp, but that MIGHT be a good tradeoff for you(you decide)
== How to use unlimited attack with FMA ==
Set up all 10 manual kami spots right next to each other, change delay to 13000, press start manual kami OR
use regular kami with delay 20000 and kamimakersurer at 15000
MORE instructions:
= Instructions for full map loot =
Yes, you can use this while FMA botting, use auto-N
*godmode or auto-HP highly suggested, or else you will die
- ENABLE AUTOLOOT
- Use WASD tele to go to start of first platform, press "Set 1"
- Go to end of that platform using WASD tele, press "Set 2"
- go to start of second platform, press set 3; go to end; press set 4.. and so on...
Go from right to left, repeat this until set 10.. even numbers being start points, odd numbers being end points.. you'll only ever go in a straight horizontal line. If you want to set it up for just like 4 platforms, you can repeat a number (e.g. press set 1 and set 3 at the same spot, and press set 2 and set 4 at the same spot)
Enable OSL
Play around with sesh delay and speed.
Sesh delay MUST be greater than the time it takes for you to slide through all 5 platforms
If you're FMA botting and want to loot your own stuff: 100000
If you're just looting other people's stuff: 20000 *I suggest you do this at maps where killers don't pick up drops
== If you're crashing ==
1. Check the last couple of post if people have been saying stuff like "detected", if yes, wait for a newer version
2. Upgrade to latest version/revision
3. Inject this dll WITHOUT any other dlls or any bypass (just to check if it works, you can inject them again later)
4. Remember to close your injector after injecting
5. If it still crashes; make a post including: any errors you got, did maple stop responding - or did it just disappear, and what you were doing when you crashed.
Were you changing numbers while associated hack was enabled? (green), next time, don't
== Instructions for new feature slide ==
Instructions for Slide:
You'll need some basic intuition to get going :
Imagine an imaginary square area of where you want to slide. You'll slide length wise.
See that yellow set button? See the two numbers in front of it?
The first number determines how much distance there is between each horizontal "line"
The second number determines the speed of the "scan"
Recommended numbers for yellow button:
Medium map: 80, 50
Huge map: 100, 300
- Use WASD tele to move to top left corner, press green set button
- Use WASD tele to move to bottom right corner, press blue set button
- Press start slide
Now you're sliding! You can either use this in conjuction with an attack, a loot, or both. Or you could just use this to annoy people in Henesys. Video coming soon.
Each time you change something please just disable and re-enable slide to apply the changes.
== Pseudo FMA ==
Requirements:
- Either (A) be able to make ranged attacks in the air OR ( be able to attack with mobbing skills in the air (shining ray or that phantom 1st job mobbing skill)
- To see if you can attack in the air; fall a long distance, and see if you can attack while you're falling
To see the magic of PseudoFMA first hand, please just go to Jesters, GO TO TELE TAB - change the delay from 3000 to 100. And press "start manual kami". Then focus on maple story window and hold down your mobbing or ranged skill key. Tadaaaaaa, pseudoFMA! Okay, now, that was only for the jesters map. To set up your own pseudo-FMA:
== Start at tele tab ==
1. Go around with WASD tele to the first of the ten spots you want to tele to
2. NOTE: WASD tele is crucial, you must be using it
3. Make sure your feet are above ground and press first "set" button
4. Go to next spot with WASD tele (click and reclick button), press second "set" button
5. Repeat. All ten spots MUST be set.
6. Change delay to 100 milliseconds
7. Press "start manual kami"
*** LET ME KNOW HOW IT WORKS FOR YOU! ***
== Manual kami instructions ==
1. Go around with WASD tele to ten spots you want to tele to
2. NOTE: WASD tele is crucial, you must be using it
3. Make sure your feet are above ground and press first "set" button
4. Go to next spot with WASD tele (click and reclick button), press second "set" button
5. Repeat. All ten spots MUST be set.
6. Press start
* the 3000 default interval is pretty nice
* go to jesters and press start with default numbers for a demo
== Zakum and alien walk ==
- *** This will get you to zakum or alien base corridor 6 IF YOU'RE LUCKY ***
- ** If you're bad luck Brian and a monster hits you at just the right time, press abort and walk the rest of the way or tele back to town if you're feeling lucky
- *If it doesn't work please try making maple a higher resolution
- If it still doesn't work, post, and I'll make the delays longer
- If something goes wrong, click abort
Zakum walk:
- Go to el nath
- Take the cab to Ice Valley 2
- Talk to the guy to get to Sharp Cliff 1
- MAGES PLEASE ENABLE MAGIC GUARD
- Press the "walk to zakum" button, and wait
Alien walk:
- Go to NLC
- MAGES PLEASE ENABLE MAGIC GUARD
- Press the "walk to aliens" button, and wait
*Looking for feedback from whoever uses the zakum walker
== Saving settings ==
Type in a file name, click save settings. Your file will appear in your maplestory folder - you can now share this with others!
KNOWN ISSUE: You can only save settings once every time you inject. You can load any files freely though.
== Loading settings ==
Type in a file name, click load settings.. if you make a typo you crash lol.. Make sure the file you want to load is in your maplestory folder, exclude the ".RebeccaBlack" extension
==Grenade instructions==
* I think I might have fixed it, please report back *
Move maplestory to the top left hand corner of your screen. When I say top left, I MEAN top left.
Make sure top left corner of trainer is visible, and not overlapping maplestory
Start auto-grenade, come back and tell me if it works
Known issue: once you start, it's pretty hard to stop - so activate other hacks first
== Automatic set up for jester loot! For the ppl who were having trouble setting it up.. ==
- Put "jesterwalk.RebeccaBlack" in your maplestory folder
- Put "FullTimeJesterLoot.RebeccaBlack" in your maplestory folder
- Type in "jesterwalk" in the file name at the top, click load settings
- Press the "walking?" button in teletab
- Press first go button, wait... press second go button, wait... press third go button, wait...
- Type in "FullTimeJesterLoot" in the file name at the top, click load settings
- Enable auto loot in auto stuff
- Enable OSL in teletab
Preset settings
To load, type in the name (excluding extension) in the file name box and click load
make sure to change the number near WASD tele and near OSL to 70. The one that says "slower = smoother"
**enable auto-MP and HP beforehand**
FullTimeJesterLoot - go to jesters, enable autoloot, enable OSL
JesterLootandFMAJett - (have FMA enabled) go to jesters, enable autoloot, put tornado on N, enable auto-N, enable OSL
diznoob-alienbase5 - enable any autoattack, press "start manual kami"
diznoob-alienbase6 - enable any autoattack, press "start manual kami"
mp3slide - enable OSL, enable any autoattack, enable autoloot (only for air attacks)
== walks: just go to start location and press the go buttons in order ==
dragonwalk- (will go to skelegons) leafre, cab to enterance to dragon forest
mp3walk - singapore, cab to trend zone metropolis
galloperawalk - singapore, cab to kampung village
jesterwalk - NLC, cab to mansion
downorbis - Orbis
downorbis2 - continue on from down orbis, at set 5 use return to town
This FMA, unlike most .wz edits, will not DC you
*perfectly compatible with Leisure Trainer
*Includes new tornado FMA for pirate, thunder breaker, and phantom
Instructions - please follow:
*might not be compatible with skill.wz godmode edit, if it doesn't work restore skill.wz to original
1. Run gamelauncher
2. Run temp leisure
3. Press F1 firmly for godmode OR press F2 firmly for (godmode + FMA)
Do NOT choose both F1 and F2
4. Close temp leisure
5. [OPTIONAL]Inject your stuff, close injector
6. Press play - ONLY USE FMA SKILLS NO OTHER SKILLS if you chose to press F2
ONLY USE ONE OF THE SKILLS LISTED BELOW IF YOU PRESSED F2 - IF YOU PRESSED F1 you can use any skill
IF YOU USE ANY OTHER ATTACK SKILL YOU WILL DC
CURRENT FMA SKILLS:
-Pirate's 2nd job - Grenade
-Dual Blade's 4th (Blade Specialist) - Flashbang
-Jett's 1st job - Tornado Uppercut
-Cannoneer's 2nd job - Barrel Bomb/Explosion
-Night Walker's 3rd job - Poison Bomb
- Probably pirate 2nd job tornado - PHANTOM STEALABLE
Credits for godmode and fma y60:
aasdf GabeNewell bob343
Credits for leisure trainer y60:
Credits to KPopLuvr for idea of dynamic title (visually appealing)
Credits to aasdf for v113 pointers and arrow tele script
Credits to mateopp for v114 and v115 pointers
Credits to TwistedMarine for youtube tutorial
Credits to jackster for help with mob locations
Credits to Goomba for mob pointers
Credits to DrR for the tubi
Credits to TwistedMarine for help in improving botting and making tutorial video(s)
Credits to HypnoSmiley for v116 pointers
this trainer actually wouldn't work if it wasn't for the people supplying the pointers BTW lol y01:
Looks like sm1 opened up paint and made that shit up
What injector should i use ? Vita injevtor "injecting" but the trainer not opening
Originally Posted by sprmni
What injector should i use ? Vita injevtor "injecting" but the trainer not opening
Try spark
Perx still work? I haven't hacked on gms in a while getting back into it trying to make some mesos (:
My game's crashing so i think its detected; same with hypno one
oh yea perx still works but like how do i run this i tried injecting and nothing happened the same thing happened with ur other hack u posted i think people are having problems with it u gotta post like a tutorial or something explaining how to use it.....
Originally Posted by 064703291
oh yea perx still works but like how do i run this i tried injecting and nothing happened the same thing happened with ur other hack u posted i think people are having problems with it u gotta post like a tutorial or something explaining how to use it.....
To use the hack, what you have to do is use the injector:
1. Upload your .dll file (the hack) to the injector
2. Use Maplestory.exe as the process name
3. Run Maplestory
4. You're hacking
If that doesn't work, try a different injector.
This hack hasn't worked for me since early this morning though... I think it's detected Blitz!
$%#% yea finally figured out how to use it.....(i use the game launcher so it might be a bit different) but when i open it up hit yes to administrator stuff, u wanna inject it before you hit the play button.......dam that was so hard for such a small detaill
thanks works like a charm :>
Originally Posted by sprmni
What injector should i use ? Vita injevtor "injecting" but the trainer not opening
Either your not injecting right or you should use a different injector
Try injector gadget or PerX
---------- Post added at 04:38 PM ---------- Previous post was at 04:33 PM ----------
Originally Posted by darkfx23
To use the hack, what you have to do is use the injector:
1. Upload your .dll file (the hack) to the injector
2. Use Maplestory.exe as the process name
3. Run Maplestory
4. You're hacking
If that doesn't work, try a different injector.
This hack hasn't worked for me since early this morning though... I think it's detected Blitz!
Yea hack is detected crashes after login of account for me
Originally Posted by omegaflare
Either your not injecting right or you should use a different injector
Try injector gadget or PerX
---------- Post added at 04:38 PM ---------- Previous post was at 04:33 PM ----------
Yea hack is detected crashes after login of account for me
Created my character, attempted to add skill points and crashed and was a/b. Didn't move my character or anything just bam a/b.
Hack ish detected :P
umm i cant get the full map attack to work can someone help?
uh just confused bout how some of this stuff works....like the kami, i set all of the points fine but when i go to choose any of teh options like slide nothing happens.....and the other thing im a bit confused about the god mode and full map attack stuff can some one clearify the posses of using those.....ty