Accidently messed with bios settings on new comp, no display signal.

[SynqZ]

So long story short, I bought my comp parts, put em together, it worked. I was going to install windows but was looking for boot device thingy. I ended up changing a fuck ton of shit and now my monitor is saying "Display: No signal".
I have already attempted the CMOS battery removal, left it out for 2 hours and put it back in. The clr_cmos pins on my motherboard do not do anything when touched for around 10seconds..
Power is off, unplugged and I held down the power button to remove the residual power.

helppp

[danieel]

A friend of mine sent his motherboard to warrantly because of BIOS settings.
BIOS is very hard or impossible to recover.

1. Unload power wit your fingers;
2. Remove battery for 10 seconds;
3. clear cmos

I think you already did this.

Best of luck,
Zerokj

[SynqZ]

Nevermind, found out I can just buy a new battery and replace it. Ordered one and praying that it works :/

[DankKlan]

Is there a way you can contact a proffesional in your area? At this point you may need one... Praying only works for starving african children on facebook.

[SynqZ]

No success with the battery, still the same problem. I have contacted gigabyte and currently waiting for a reply from them.

[TheMaskedOne]

No success with the battery, still the same problem. I have contacted gigabyte and currently waiting for a reply from them.

Someone already answered your question on your motherboard you will find a removeable battery. Remove it for arround 10 - 20 seconds after that place the battery in it again. Now your bios should be resetted to default again.

[spdgear]

Yeah... Never touch Bios unless you are super pro with computer. It can seriously cause a lot of problems like this later on.