Fixing Hans Base

I have been recently working with Hans Base but whenever I test it on Combat Arms it causes CA not to start up? I haven't messes with any signatures or Detours but still wont work. I've talked to matypatty and tried putting in "IsGameReadyforHook" but it still didnt work. Any help would be appreciated.


Thank You.

Do you have the updated LtClient Address, and the updated DevicePtr?

I've never seen hans base, so i can't be much help.

Lol serisouly

even with a invalid hook...the message box could still pop up..lol @ acid.

Not 100% sure that this is what the base does but I'm pretty sure. It uses sigsearching to find createdevice and then gets the virtual table which you can find the addresses for functions like endscene, reset, and present.

well if its not hooking right that would probably be why CA wont start
but the message box after the hook so if it pops up u know u hooked right
and if CA still doesnt start then its not the hook

once again this still doesnt belong in this section

rules for help section
-Posting errors you receive while playing CA
-Asking for help when CA is crashing
-Posting errors you get when using hacks

this thread doesnt fall into any of those categories
and he is right he will not fix his problem in the help section he is better off in the source code section