Sinbot glitch?

Hey,
On the latest version of SinBot, while I've been trying to bot Dethrone the White Tyrant, it will load up everything correctly and then when the kobolds are running towards me, the pally trans triggers. It gets about half way through transforming and then the game just freezes. I can stop the bot, and everything is still frozen, eventually a message pops up that says vindictus is not responding and I have to close the program. Wondering if I am the only one having this problem and if there is anyway to fix it. Thanks.

I am having the same exact problem!
i thought it was just me and my computer but i guess not.. i can do other battles fine with the bot, except that and desisive battle

could be your computer running out of memory, what's the amount of ram you two guys have?
Sinbot has no direct correlation with vindictus, so anything that vindictus is doing is either due to your system being too low to handle it's graphics spam, or other memory (possibly hard drive) related issues.

i have 4 GB of ram
64bit
Amd Anthlon 1.6 Ghz

what athlon? Single, Dual, or quad core?

its AMD athlon(tm) II X2 250u Processor

It's the change your height command.I had that problem too. Just unbind anything that has "cc_change_figure_height" and you should be good to go.

They can't simply UNBIND it, that would defeat the entire function of the bot, and it's not the command, it's the action OF the command being performed.
Try changing the height, not sure if you can in sinbot, but check the settings files, and things like that, and see if there's a way too, don't change it too much, because that'll keep it from doing what it's supposed to, but try dropping it down just a hair.
Also try changing the amount of time in between the height modifiers. The LARGE height is the one giving you trouble, so set it to something a little lower, and try to make it go back to regular faster.
Again, not sure if these are possible, hopefully Zaia will make it where it is later, he's offline atm.

Moved to help.

There are 3 main problems with the height command that I can tell.

Problem 1:
Your computer can't handle the massive change in height, and is unable to process it effectively. Thereby freezing or lagging your computer severely.
Solution:
Change the bind. It's the command that reads:
bind "[" "cc_change_figure_height X"
Where X is the number of the height change (1 is normal height)
Try bringing it down to 100. That might help. I do have it set to the number it's at for a reason, as some maps have much larger areas that you need to cover, like the polar bears.

Problem 2:
The delay is too small/large, and it doesn't activate the cutscene, thereby never skipping to the boss.
Solution:
Change the heightdelay= line in the settings.ini file.
Some of my testers have said 500 works for them, some have said 5000+. I'm pretty sure it all depends on your computer speed.

Problem 3:
The command is bound to something else as well, causing it to crash shortly after using it.
Solution:
Make sure that your binding is for one command only. I'm running into lots of problems with people having multiple commands bound at the same time.