Cannot find height address
Cannot find height address
I begin a scan for 4 byte unknown at the beginning of a ladder. I climb up and search for increased. Climb back and down and search for decreased. When the addresses narrow down to one hundred, I am left with a few static addresses that, when shifting values, do absolutely nothing to my characters height.
It'd be nice if someone could explain perhaps a better process for finding the address.
It'd be nice if someone could explain perhaps a better process for finding the address.
same that dint work but for me jumoing does the trick but u have to scan in air so have warrock in bacground press space and klik scan and then scan when u get down for decrease
U have find the Z axis, for find it u must scan in Unknow value initial scan mode, and value type= float; fisrt scan, now u go to up place, and next scan with scan type in "increasse value", now u go to down, and next scan for "Decress value"... repeat this two steps for see few address, change his values for 1000 for example, and u see the high value.
This thread is closed for replies.
