Microphone help
Everything is plugged in..
Screenshot by Lightshot
Screenshot by Lightshot
Microphone help
When you speak or tap it, does the level indicator rise? Did you check the properties (specifically the levels tab)?
Originally Posted by Alen
When you speak or tap it, does the level indicator rise? Did you check the properties (specifically the levels tab)?
Originally Posted by kingzwhip
The indicator does not rise it says it's not plugged in and it is. Could it be really old drivers ?Screenshot by Lightshot
If you have another PC close by check if the microphone works there, if you have an alternative microphone jack (usually there's one on the back and one on the front panel) try switching jacks to see if that helps.
Originally Posted by Alen
Doubt it, but you can check for newer drivers. I personally don't have Realtek drivers at the moment, but I suggest you go check out their control panel for extra settings. The fact that the indicator doesn't rise when you tap it though might indicate that the microphone is physically damaged, should the drivers turn out to not mess with the microphone
If you have another PC close by check if the microphone works there, if you have an alternative microphone jack (usually there's one on the back and one on the front panel) try switching jacks to see if that helps.
If you have another PC close by check if the microphone works there, if you have an alternative microphone jack (usually there's one on the back and one on the front panel) try switching jacks to see if that helps.
Originally Posted by kingzwhip
I can still hear out of it. And it takes 2 wires 1 for mic 1 for headphones. I switched the mic and headphones and the headphones worked where the mic was but the mic wasn't working. It must just be the wire for the mic or i disabled it somewhere:L
Do you need drivers for the mic?
Originally Posted by kingzwhip
Everything is plugged in..
Screenshot by Lightshot
Screenshot by Lightshot
Originally Posted by [SMA] Paradise`
Are you trying to use it on Vent or Teamspeak? Or what?
Request Solved, Just had to disable front panel jack detection.
@Alen
@Alen
This thread is closed for replies.
